cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
653
Views
8
Helpful
7
Replies

IPX in Campus

MortezaSoltani
Level 1
Level 1

In our layer3 campus there are some novell / ipx workstations in different buildings . Because of missing ipx routing capability in 3550 swithes , connection between hosts was losted .

Is there any way to connect these workstations?

7 Replies 7

asanemeterio
Level 1
Level 1

Hi,

If you must use routing protocol the better solution is creta a tunnel interface and send IPX traffic for this tunnel.

Hi

what kind of tunnel may i use with 3550 swithes ?

would u please introduce a reference document?

asanemeterio
Level 1
Level 1

continue..

Sorry,

see this link, is a good example about how configure

http://www.cisco.com/en/US/partner/tech/tk827/tk369/technologies_configuration_example09186a0080093f70.shtml

agusti

I have guest level access and your mentioned linke are not accessible for me .

may you send the page to my email .

Morteza74@yahoo.com

I send an email with this document

agusti

Dear friend

Thanks for your email ,but as i mentioned before, i need ipx connectivity in campus area which contain Cisco 3550 switches , without IPX routing capability . In the document GRE tunnel is maded by two router and IPX routing command.

Regards

glen.grant
VIP Alumni
VIP Alumni

You might look into fall back bridgeing for the 3550's . The 3550's need the EMI image to support this

http://www.cisco.com/en/US/products/hw/switches/ps646/products_configuration_guide_chapter09186a00802cb7c6.html.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: