01-11-2022 09:17 AM
Hello Community !
I know this will sound stupid but I have to ask...!
We have a (CatOS) Cat.6509 connected to a Nexus 5672.
The c6509 reports :
> (enable) sh spantree summ
Spanning tree mode: RAPID-PVST+
while the Nexus reports :
# sh span sum
Switch is in rapid-pvst mode
Was I wrong to assume these two are the same with different syntax ?
We're troubleshooting weird, "phantom" like behavior (i.e. working / non-working, and vice versa) and I'm trying to verify everything...
I do not have any indication that this is actually an STP issue - just trying to make sure.
Thanx in advance.
Costas
Solved! Go to Solution.
01-12-2022 06:27 AM
yes agreed ....IOS and nexus bit different but same goal.
01-11-2022 09:30 AM
Hi,
Similar but not exactly the same
Have a look at this post:
https://community.cisco.com/t5/switching/pvst-rstp-and-rapid-pvst/td-p/1459012
HTH
01-14-2022 11:20 AM
01-11-2022 09:36 AM
they work as same but nexus command syntax same as below explained :
01-12-2022 05:48 AM
01-12-2022 06:27 AM
yes agreed ....IOS and nexus bit different but same goal.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: