07-05-2016 10:59 AM - edited 03-08-2019 06:30 AM
I have a Cisco switch that has a couple VLAN's, VLAN 10, 50 and VLAN 1000. The previous two can be pinged but I am unable to ping VLAN 1000. I am not sure if it is the numbering scheme that is the issue or if I have to go digging some more to solve the problem.
07-05-2016 11:19 AM
Hello friend,
i think vlan 1000 should not be a problem. Could you please share the specific vlan configuration and switch port config for vlan1000 on which you have connected your testing device
I just assume that your config also looks like this
vlan 1000
name xxxx
int vlan 1000
ip add
And switch config for the testing device
int gi0/2
switchport mode access
switchport access vlan 1000
if this is the config I think it should work without any issues
thanks
07-05-2016 04:06 PM
Switch1#show vlan
VLAN Name Status Ports
-----------------------------------------------------------------------------------------------
1000 VLAN1000 Active Fa1/0/5, Fa1/0/7, Fa1/0/8,
Fa1/0/9, Fa1/0/12, Fa1/0/13
Fa1/0/14, Fa1/0/15, Fa1/16
Fa1/0/17, Fa1/0/18, Fa1/0/19
Fa1/0/20, Fa1/0/21, Fa1/0/22
Fa1/0/23, Fa1/0/24
07-05-2016 04:10 PM
VLAN Type SAID MTU Parent RingNo BridgeNo Trans1 Trans2
--------- ------- ------------- ------- ---------- ----------- -------------- --------- ---------
1000 enet 101000 1500 _ _ _ 0 0
Remote SPAN VLAN
-----------------------------
Disabled
07-05-2016 04:13 PM
we basically are pinging from the computers hooked up to the switch by CAT5 which are accessing the backend of a server.
07-05-2016 04:19 PM
vlan 10 ip address 192.168.1.200
vlan 50 ip address 192.168.5.200
vlan 1000 ip address 192.168.0.200
all with a subnet mask of 255.255.255.0
07-06-2016 12:26 AM
Hi,
are you able to ping gateway vlan 1000 gateway ip from vlan 1000 ?
please provide the below outputs
show ver
show run int gig0/1 (access ports from vlan 1000)
and check are you learning the MAC address on the vlan 1000
07-06-2016 12:28 AM
Do you have only one vlan configured on the switch ? On which vlan the backend server is connected ?
07-06-2016 11:09 AM
All the vlan's are connect through one LAN on the server using a Hyper V vswitch. I can ping the gateway ip 192.168.0.1 no problem.
10-19-2016 03:33 PM
VLAN 1000
07-06-2016 11:18 AM
show ver
Cisco IOS Software, C3750 software (C3750-IPSERVICESK9-M), Version 12.2 (55) SE3, RELEASE SOFTWARE (fc1)
The access ports are 5, 8, 7, 9,12 - 24 for vlan 1000
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: