hi all,
i have 2960 and i enabled jumbo frames but after that my openfiler 2xnic won't bundle anymore with lacp, status will be (I) or stand alone.
interface GigabitEthernet0/1
description opefiler1
switchport access vlan 181
switchport mode access
switchport nonegotiate
channel-group 1 mode active
spanning-tree portfast
end
interface GigabitEthernet0/2
description opefiler2
switchport access vlan 181
switchport mode access
switchport nonegotiate
channel-group 1 mode active
spanning-tree portfast
end
is there a way i could make this bundle with jumbo frames on? I tried also using command trunk but no luck too.
thanks for any comment you may add.