02-14-2015 02:27 AM - edited 03-07-2019 10:39 PM
Hi All,
We're using 2 P2P link from different providers ( one 30 Mb and second 20 Mb) from Main POP to Remote POP.
We required load balance between both the P2P links with failover, but one of the port in suspended mode while channel-group apply.
Remote POP- Cisco 3400ME
Remote-POP-3400ME#sh int gi0/1
GigabitEthernet0/1 is up, line protocol is down (suspended)
Hardware is Gigabit Ethernet, address is 0016.9d26.5101 (bia 0016.9d26.5101)
Description: *** P2P-1 ***
MTU 9000 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 3/255, rxload 14/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:29, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 5681000 bits/sec, 757 packets/sec
30 second output rate 1306000 bits/sec, 531 packets/sec
127102505 packets input, 144344310802 bytes, 0 no buffer
Received 4570664 broadcasts (2231603 multicasts)
0 runts, 0 giants, 0 throttles
10 input errors, 10 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 2231603 multicast, 0 pause input
0 input packets with dribble condition detected
interface GigabitEthernet0/1
description *** P2P-1 ***
port-type nni
switchport trunk allowed vlan 1,3-4094
switchport mode trunk
load-interval 30
channel-group 21 mode active
end
Remote-POP-3400ME#sh int fas0/23
FastEthernet0/23 is up, line protocol is up (connected)
Hardware is Fast Ethernet, address is 0016.9d26.5119 (bia 0016.9d26.5119)
Description: *** P2P-2 ***
MTU 1546 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 4/255, rxload 28/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:24, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 11147000 bits/sec, 1390 packets/sec
30 second output rate 1944000 bits/sec, 1112 packets/sec
5404734 packets input, 1041290192 bytes, 0 no buffer
Received 4924815 broadcasts (2259127 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 2259127 multicast, 0 pause input
0 input packets with dribble condition detected
interface FastEthernet0/23
description *** P2P-2 ***
port-type nni
switchport trunk allowed vlan 1,3-4094
switchport mode trunk
load-interval 30
channel-group 21 mode active
end
====================================================================
MAIN POP- cisco 3750
MAIN-POP-3750-STACK#sh int gi2/0/7
GigabitEthernet2/0/7 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0019.e78b.c607 (bia 0019.e78b.c607)
Description: *** P2P-1 ***
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 6/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP
Media-type configured as connector
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 3/75/0/0 (size/max/drops/flushes); Total output drops: 103937
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 2660000 bits/sec, 2181 packets/sec
30 second output rate 27366000 bits/sec, 2723 packets/sec
31887654718 packets input, 10045858003774 bytes, 0 no buffer
Received 467095011 broadcasts (214841125 multicasts)
0 runts, 27 giants, 0 throttles
22 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 214841125 multicast, 406425160 pause input
interface GigabitEthernet2/0/7
description *** P2P-1 ***
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,3-4094
switchport mode trunk
speed 100
load-interval 30
channel-group 21 mode active
MAIN-POP-3750-STACK#sh int gi2/0/10
GigabitEthernet2/0/10 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0019.e78b.c60a (bia 0019.e78b.c60a)
Description: *** P2P-2 ***
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP
Media-type configured as connector
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 2449
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 2000 bits/sec, 4 packets/sec
30 second output rate 55000 bits/sec, 62 packets/sec
13820128 packets input, 4202349171 bytes, 0 no buffer
Received 2375120 broadcasts (810650 multicasts)
0 runts, 0 giants, 0 throttles
15 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 810650 multicast, 478680 pause input
0 input packets with dribble condition detected
28535531 packets output, 16494317102 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
interface GigabitEthernet2/0/10
description *** P2P-2 ***
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,3-4094
switchport mode trunk
load-interval 30
channel-group 21 mode active
Please advise me to fix the issue and we are able to achieve and use with load-balance via etherchannel.
Thanks in ADV,
02-14-2015 04:03 AM
Here are the questions:
1- Does the link comes up individually when connected? If yes
2- Shut down the ports both the end.
3- Configure the port-channel first then configure the ports accordingly and then do no shut on the physical ports.
Kindly revert back with the update after this.
REgards
Inayath
02-14-2015 08:44 AM
Hi Inayath,
Remote POP - Cisco 3400
%EC-5-CANNOT_BUNDLE2: Fa0/23 is not compatible with Gi0/1 and will be suspended (MTU of Fa0/23 is 1500, Gi0/1 is 9000)
FastEthernet0/23 is up, line protocol is down (suspended)
Hardware is Fast Ethernet, address is 0016.9d26.5119 (bia 0016.9d26.5119)
Description: *** P2P-2 ***
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:11:15, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 56000 bits/sec, 65 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
658410 packets input, 573817450 bytes, 0 no buffer
Received 202028 broadcasts (92075 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 92075 multicast, 0 pause input
0 input packets with dribble condition detected
333031 packets output, 77587439 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
GigabitEthernet0/1 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0016.9d26.5101 (bia 0016.9d26.5101)
Description: *** P2P-1 ***
MTU 9000 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 3/255, rxload 30/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:16, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 12136000 bits/sec, 1230 packets/sec
30 second output rate 1557000 bits/sec, 921 packets/sec
3730111 packets input, 4532149684 bytes, 0 no buffer
Received 189538 broadcasts (88491 multicasts)
0 runts, 7 giants, 0 throttles
20 input errors, 13 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 88491 multicast, 0 pause input
0 input packets with dribble condition detected
2663637 packets output, 494552940 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
02-14-2015 09:14 AM
Hi Inayath,
Thanks a ton,
Now it's working
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
------+-------------+-----------+-----------------------------------------------
21 Po21(SU) LACP Gi2/0/7(P) Gi2/0/10(P)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide