Hello,
I have a Customer where his Layer 2 encapsulated traffic is remark with a priority bit 5 even is send with mark of 0.
He is using Me3400s and is using L2 protocol tunneling
Test equip Sender ----gi0/1 Me3400 gi 0/13 -----Me6500 --------(Tunnel)------Juniper Switch----( Recever equipment )
Im assuming this is how it should work, Cos for the encapsulated traffic such as CDP,STP,LLDP is always 5 right ?
interface Port-channel3
port-type nni
switchport trunk allowed vlan 2,90,100-299,4092
switchport mode trunk
load-interval 30
spanning-tree bpdufilter enable
interface GigabitEthernet0/1
port-type eni
switchport trunk allowed vlan 140-143
switchport mode trunk
switchport vlan mapping 100 dot1q-tunnel 140
switchport vlan mapping 300 dot1q-tunnel 142
switchport vlan mapping 1001 dot1q-tunnel 140
switchport vlan mapping 1003 dot1q-tunnel 142
switchport vlan mapping 2001 dot1q-tunnel 141
switchport vlan mapping 2003 dot1q-tunnel 143
switchport vlan mapping default drop
bandwidth 100000
load-interval 30
l2protocol-tunnel cdp
l2protocol-tunnel lldp
l2protocol-tunnel stp
l2protocol-tunnel vtp
!
interface GigabitEthernet0/13
port-type nni
switchport trunk allowed vlan 2,90,100-299,4092
switchport mode trunk
load-interval 30
channel-protocol lacp
channel-group 3 mode active
!
Kindly correct me if im wrong
Thank you