03-30-2020 02:39 PM
I seem to be having issues creating a LACP connection between a 3750x and 4500x switch. I've set a lot of these up on 3750x switches but on the 4500x there is no dot1q option.
Here is my 3750x config
interface Port-channel36
description To_Storage_Switch_4500x
switchport trunk allowed vlan 16
switchport trunk encapsulation dot1q
switchport mode trunk
Here is my 4500x config
interface Port-channel1
description To_RDS_Switch
switchport
switchport trunk allowed vlan 16
switchport mode trunk
Any suggestions?
Thank you
Solved! Go to Solution.
03-30-2020 04:24 PM - edited 03-30-2020 04:26 PM
switchport trunk encapsulation dot1q is an old command and no longer needed as most newer IOS, dot.1q is default and so show run does not show it any more.
HTH
03-30-2020 03:03 PM
Might of figured it out. I had no access ports with vlan 16 on them and until I did that vlan 16 didn't show up on the switch.
But out of curiosity why doesn't the 4500x have the dot1q encapsulation option?
03-30-2020 04:24 PM - edited 03-30-2020 04:26 PM
switchport trunk encapsulation dot1q is an old command and no longer needed as most newer IOS, dot.1q is default and so show run does not show it any more.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: