cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
825
Views
5
Helpful
5
Replies
Highlighted
Beginner

LACP between Cisco ASR 9006 and Huawei

I need to configure LACP between Cisco  ASR 9006 and Huawei device. But I couldn't found any doc or related material. 

Can find LACP between normal cisco ios and Huawei configurations over the Internet. Not with IOS-XR.

 

Please help...

2 ACCEPTED SOLUTIONS

Accepted Solutions
Highlighted
VIP Expert

IOS XR bit different core :

 

you can start from below :

 

https://fryguy.net/2012/04/27/cisco-ios-xr-interface-bundles-aka-etherchannel-or-802-3ad/

 



BB


*** Rate All Helpful Responses ***

View solution in original post

Highlighted
VIP Expert

Alwys Port-channel recommended to be 2-4-8-10 is good to balance between chassis (odd number not recommended)

this document still valid how the Loadbalance works in basic.

 

https://www.cisco.com/c/en/us/support/docs/lan-switching/etherchannel/12023-4.html

 

post the config and out put of below to understand :

 

show bundle bundle-ether X  (where X is your channel number)

show bundle status

 



BB


*** Rate All Helpful Responses ***

View solution in original post

5 REPLIES 5
Highlighted
VIP Expert

IOS XR bit different core :

 

you can start from below :

 

https://fryguy.net/2012/04/27/cisco-ios-xr-interface-bundles-aka-etherchannel-or-802-3ad/

 



BB


*** Rate All Helpful Responses ***

View solution in original post

Highlighted

Thanks Balaji

Highlighted

Hi Balaji,


We have configured the LACP.

There are 3 links (10G) with LACP mode on. When we monitor the traffics over the links we have found that some traffics unbalances.

link 1: 8G

link 2 : 8G

link 3 : 3G


What can be the cause for this?

Highlighted
VIP Expert

Alwys Port-channel recommended to be 2-4-8-10 is good to balance between chassis (odd number not recommended)

this document still valid how the Loadbalance works in basic.

 

https://www.cisco.com/c/en/us/support/docs/lan-switching/etherchannel/12023-4.html

 

post the config and out put of below to understand :

 

show bundle bundle-ether X  (where X is your channel number)

show bundle status

 



BB


*** Rate All Helpful Responses ***

View solution in original post

Highlighted
Beginner

Thanks Balaji for your support

Content for Community-Ad