LACP between Cisco ASR 9006 and Huawei

[SMK91]

I need to configure LACP between Cisco  ASR 9006 and Huawei device. But I couldn't found any doc or related material. 

Can find LACP between normal cisco ios and Huawei configurations over the Internet. Not with IOS-XR.

Please help...

[balaji.bandi · Accepted solution]

IOS XR bit different core :

you can start from below :

https://fryguy.net/2012/04/27/cisco-ios-xr-interface-bundles-aka-etherchannel-or-802-3ad/

[SMK91]

Thanks Balaji

[SMK91]

Hi Balaji,

We have configured the LACP.

There are 3 links (10G) with LACP mode on. When we monitor the traffics over the links we have found that some traffics unbalances.

link 1: 8G

link 2 : 8G

link 3 : 3G

What can be the cause for this?

[balaji.bandi · Accepted solution]

Alwys Port-channel recommended to be 2-4-8-10 is good to balance between chassis (odd number not recommended)

this document still valid how the Loadbalance works in basic.

https://www.cisco.com/c/en/us/support/docs/lan-switching/etherchannel/12023-4.html

post the config and out put of below to understand :

show bundle bundle-ether X  (where X is your channel number)

show bundle status

[SMK91]

Thanks Balaji for your support