10-19-2015 05:56 AM - edited 03-08-2019 02:16 AM
Hi
can cisco 4000 series router support LACP or ether channel on the 4 on board GE ports?
need to connect to cisco catalyst switch to aggregate the bandwidth.
thanks
10-19-2015 06:58 AM
Not sure off the top of my head if it supports LACP but you could just configure the ports for "on" instead of using LACP.
10-19-2015 03:35 PM
You are off-topic here. Use blue [ EDIT ] button to move this thread to LAN, Switching and Routing
I'm sure an expert will respond you then.
10-20-2015 03:47 AM
Hi
interface Port-channel1
ip add x.x.x.x y.y.y.y
!
interface GigabitEthernet0/1
channel-group 1
!
interface GigabitEthernet0/2
channel-group 1
Try this . I think this will work...
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: