Latency test between end points
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-16-2007 03:25 AM - edited 03-05-2019 07:27 PM
Hi all,
We have the following design:
server-1gbs-4500-10gbs-6500-10gbs-6500-10gbs-4500-1gbs-SAN
Is there a way to test the latency between these two end points?
Is there a document that says howmuch latency there can be?
Thnx in advance.
regards
Ruud
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-16-2007 05:56 AM
im not sure i understand the question. are you asking how to interject and test varying latencies or asking just based on the connection types what theoretical latency should be vs comparing that to actual latency
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-16-2007 06:05 AM
i would like to know this:
based on the connection types what theoretical latency should be vs comparing that to actual latency.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2007 04:47 AM
configuring ip sla would be a right one
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-20-2007 12:47 AM
With IP SLA, can i guaranty a delay of maximum 6ms?
