08-24-2015 03:09 PM - edited 03-08-2019 01:29 AM
Hello, I have just bought a CISCO SG-300 52 Switch and a CISCO 2811 Router. I am trying to configure SG-300 on Layer 3 mode which is done and InterVlan routing works well. However, my hosts can not communicate with router, although I can ping router's IP from inside switch console.
It seems certain commands are different with this switch model, and I couldn't yet access my router's from any of the hosts.
Can anyone explain me how to properly configure both ends, based on diagram below, so my hosts can access router and internet?
08-24-2015 03:27 PM
08-25-2015 09:54 AM
Thanks, it worked fine after I added static routes for each range on Router side.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide