cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
1230
Views
0
Helpful
6
Replies
Highlighted
Beginner

Line con 0

hello,

I have a Cisco 3560 switch which we found that the speed was set to 115200.So we tried changing the speed to 9600 in config mode and after saving, when we reload it goes back to 115200..So now we go to bootloader mode and set the speed there. still when we reboot it goes back to original 115200.

The config-register is set to 0xf.

thanks....

6 REPLIES 6
Highlighted
Rising star

I would try to change the baud rate on the switch by resetting the power and hold down the status switch until it enters rommon. type "unset BAUD" command without the quotation marks. Then reset the switch.

HTH,

Mark.

Highlighted

Hi Mark,

It did not solve the problem. Next reload and it's back to 115200. However i noticed that other configurations are saved without any issues..

well i also get this error message whenver booting the switch.

Loading "flash:c3560-ipbase-mz.122-25.SEE3/c3560-ipbase-mz.122-25.SEE3.bin"...fl

ash:c3560-ipbase-mz.122-25.SEE3/c3560-ipbase-mz.122-25.SEE3.bin: no such file or

directory

Error loading "flash:c3560-ipbase-mz.122-25.SEE3/c3560-ipbase-mz.122-25.SEE3.bin

"

then it loads the correct 122-40 image which is in the flash.

thanks..

Highlighted

That means the boot statement is incorrect and still pointing to the old IOS.

Highlighted

hi grant,

i tried giving the set boot command in boot loader mode but, it still tries to boot with the old one first...

hi mark,

i also tried setting the baud rate to 9600 using set baud rate 9600 in boot loader mode...it goes back to the 115200 after a restart..this is very strange..

hi lamav,

will be posting the outputs soon..

thanks

Highlighted

Try this instead "set BAUD 9600" in rommon.

Mark

Highlighted

Can you post the config and the outout of a "sh boot"?

Content for Community-Ad