cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
485
Views
0
Helpful
1
Replies

Linksys SGE2000P L3 mode

 

Hello Guys.

 

I have several Linksys SGE2000P switches in my network, i was checking the datasheets for these switches and they indicate that these switches can do Layer 3 routing, i need to setup VLANs in my network then use a Linksys SGE2000P switch to do the Inter-VLAN routing between the different VLANs. How do i configure the switch to operate in Layer 3 mode, i cannot see any settings in the GUI for configuring L3 routing. 

 

Thanks.

1 Reply 1

educruz
Cisco Employee
Cisco Employee

Hi,

Below one can find the reference guide. There is a section for Layer 2 and Layer 3 setup.

http://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sge2000/reference/guide/sge_refguide.pdf

Hope this helps. Let me know if it does not.

 

- Ed

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: