Hello,
I am installing a connection between Brocade MLX and Cisco 4503 using SE and SVI's. Below is the config for each. Am I missing anything like MTU Ignore or something along that nature?
*** Cisco 4503 (v15.01) Config ***
VLAN 35
name EOC_Gi1/2
!
interface GigabitEthernet1/1
description *** EOC 4/4 ***
switchport trunk allowed vlan all
spanning-tree link-type point-to-point
switchport nonegotiate
switchport mode trunk
!
interface vlan 35
ip address 10.30.254.2 255.255.255.0
!
interface loopback 0
ip address 10.254.254.101 255.255.255.255
!
router ospf 1
network 10.0.0.0 0.0.0.255 area 0
redistribute connected subnet
redistribute static subnet
**** Brocade MLX (v3.8e) Config ****
vlan 35 name To_HGW
tagged ethe 4/4
router-interface ve 35
!
router ospf
area 0
default-information-originate always
timers throttle spf 1000 1000 1000
auto-cost reference-bandwidth 10000
redistribution connected
redistribution static
!
router pim
!
interface loopback 1
ip address 10.254.100.254/32
ip pim
!
interface ethernet 4/4
port-name To-Greenwood
enable
!
interface ve 35
port-name To-HGW
ip ospf area 0
ip address 10.30.254.1/24
!
end
