cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
337
Views
0
Helpful
8
Replies

Loops detected in the network for mac?

touqeeranjum
Level 1
Level 1

Hi,

I ran into an IP conflict issue and shutdown 1 of the system so I changed the IP addresses but a few days ago I powered back on both the systems and was facing intermittent connectivity issue in one of the systems, the ping was replying then stopping then replying again.

I checked the switch and it was showing the below

Loops detected in the network for mac f8f2.1e8a.8fb0 among ports Eth1/2 and Eth1/23 vlan 50 - Disabling dynamic learning notifications for a period between 120 and 240 seconds on vlan

I reset both both system and set the original IP addresses again (different IP addresses) but now both systems are not reachable. When I check the switch for LLDP neighbours the MAC address is correct, but both systems do not appear in the MAC address table either.

I performed clear ip arp 10.1.1.233 and clear ip arp 10.1.1.234, rebooted the systems, shutdown ports, and pinged from the systems to the switch’s SVI all of which are in the same VLAN, but there is no ping response.

Can anyone suggest what else can be done ?

2 Accepted Solutions

Accepted Solutions

How does the switch side configuration look like? Is this only one Nexus switch?

 Eth1/2 and Eth1/23 vlan 50

what is this ports conneced ? what is that MAC address associated with IP ?

 

BB

=====Preenayamo Vasudevam=====

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

Thanks everyone..

I just performed a no switchport and reconfigured the port, and its working now..

View solution in original post

8 Replies 8

Mark Elsen
Hall of Fame
Hall of Fame

 

  - @touqeeranjum               On what platform  are you seeing this message ?

  M.



-- Let everything happen to you  
       Beauty and terror
      Just keep going    
       No feeling is final
Reiner Maria Rilke (1899)

Hi @Mark Elsen 

This is a Cisco Nexus 3172, NXOS: version 9.2(2)

balaji.bandi
Hall of Fame
Hall of Fame

Is this vPC then  making sure the VLAN is allowed between these vPC switches?

 

BB

=====Preenayamo Vasudevam=====

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

touqeeranjum
Level 1
Level 1

Sorry not sure what you mean by vPC, these are physical servers, 2 running ESXi and 2 are Storage servers, the issue seems to come from an ESXi server initially, but now its showing on the Storage server which was previously used as a temporary ESXi server..

how is your network connected  to nexus ?

BB

=====Preenayamo Vasudevam=====

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Each server has 4 interfaces, only the 1st interface on all servers have been assigned an IP address..

On the ESXi, 2 are for management which also carry vMotion traffic, 2 are for storage..

On the Storage also 2 are for management, 2 for storage..

On the switch side, the 1st 2 ports are on VLAN50 for all the 4 servers, but only the 2 storage servers are not reachable.

How does the switch side configuration look like? Is this only one Nexus switch?

 Eth1/2 and Eth1/23 vlan 50

what is this ports conneced ? what is that MAC address associated with IP ?

 

BB

=====Preenayamo Vasudevam=====

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Thanks everyone..

I just performed a no switchport and reconfigured the port, and its working now..