Hello
After an upgrade of a 3400 ME switch image to metro access one (340x), the switch was reloaded. After that, the only way to access the switch is the console port. I am beginner with cisco switches but I managed to configure the switch to make an upgrade through TFTP. Now I want to configure port 0/1 on vlan access mode to vlan 1. Any help on this is more than welcome. Thank you.
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 26 ME-3400-24TS-D 12.2(35)SE3 ME340x-METROACCESS-M
no aaa new-model
system mtu routing 1500
ip subnet-zero
!
no file verify auto
!
spanning-tree mode rapid-pvst
spanning-tree extend system-id
vlan internal allocation policy ascending
!
vlan 10
name management
!
interface FastEthernet0/1
speed 100
duplex full
!
interface FastEthernet0/2
shutdown
!
interface FastEthernet0/3
no switchport
no ip address
no ip route-cache
shutdown
!
interface FastEthernet0/4
shutdown
!
--More--
interface GigabitEthernet0/2
port-type nni
!
interface Vlan1
ip address 192.168.1.252 255.255.255.0
no ip route-cache
!
interface Vlan10
no ip address
no ip route-cache
shutdown
!
ip default-gateway 192.168.1.1
no ip http server
!
cisco3400#sh int fastEthernet 0/1 switchport
Name: Fa0/1
Switchport: Enabled
Administrative Mode: static access
Operational Mode: static access
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: native
Negotiation of Trunking: Off
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Administrative Native VLAN tagging: enabled
Administrative private-vlan host-association: none
Administrative private-vlan mapping: none
Administrative private-vlan trunk native VLAN: none
Administrative private-vlan trunk Native VLAN tagging: enabled
Administrative private-vlan trunk encapsulation: dot1q
Administrative private-vlan trunk normal VLANs: none
Administrative private-vlan trunk private VLANs: none
Operational private-vlan: none
Trunking VLANs Enabled: ALL
Capture Mode Disabled
Capture VLANs Allowed: ALL
