cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1171
Views
0
Helpful
1
Replies

Low TCAM entries

STUART KENDRICK
Level 1
Level 1

I've just replaced a Cat6500 w/Sup 720 in a data center switch with a Sup2T ... and a few minutes after booting, it spat out:

%QM-4-TCAM_ENTRY: Hardware TCAM entry programming failed for slot 7 intf Gi4/39 dir IN: <CONFIG_UPDATE_REQ> TCAM Req Error: FAIL (4): Low TCAM Entries (1)

Hints on what this means?  The box has been running for several hours now, no further TCAM-related messages.

IOS 15.0(1)SY1

-sk
1 Reply 1

STUART KENDRICK
Level 1
Level 1

TCAM usage seems ... trivial to me:

j4sr-b-esx#sh platform hardware capacity forwarding

L2 Forwarding Resources

           MAC Table usage:   Module  Collisions  Total       Used       %Used

                              7                0 131072       1216          1%

                              10               0 131072       1216          1%

L3 Forwarding Resources

             FIB TCAM usage:                     Total        Used       %Used

                  72 bits (IPv4, MPLS, EoM)     262144          22          1%

                 144 bits (IP mcast, IPv6)      131072           5          1%

                 288 bits (IPv6 mcast)           65536           1          1%

                     detail:      Protocol                    Used       %Used

                                  IPv4                          21          1%

                                  MPLS                           0          0%

                                  EoM                            1          1%

                                  IPv6                           2          1%

                                  IPv4 mcast                     3          1%

                                  IPv6 mcast                     1          1%

            Adjacency usage:                     Total        Used       %Used

                                               1048576       32018          3%

     Forwarding engine load:

                     Module       pps   peak-pps                     peak-time

                     7         878780    5437212  21:19:43 pst Sat Dec 15 2012

                     10        111543     191508  22:45:54 pst Sat Dec 15 2012

j4sr-b-esx#

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card