Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
351
Views
0
Helpful
2
Replies

LRE link with two CPEs

eh_ham
Level 1
Level 1

‎01-13-2007 03:52 AM - edited ‎03-05-2019 01:45 PM

Hello

I'd like to know if it is possible to make an LRE link with two CPEs.

This is to connect a far station (300 m) to a 2960 switch without the use of an LRE switch.

Thanks for answering

Labels:
0 Helpful
2 Replies 2

lgijssel
Level 9
Level 9

‎01-15-2007 06:12 AM

This wil not be possible. With this solution, RX and TX channels are frequency-multiplexed over a single wire-pair. Two CPE's will transmit & receive on the same freq.

Regards,

Leo

0 Helpful

eh_ham
Level 1
Level 1
In response to lgijssel

‎01-21-2007 09:24 AM

Many thanks L?o

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card