cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1203
Views
0
Helpful
4
Replies

LWAPP 1231G-A-K9 Reset to a stand alone AP?

davidc_86
Level 1
Level 1

hello i was wondering if anyone can tell me an easy way to reset a LWAPP 1231G-A-K9 back to a stand alone unit? i have three an they are light weight, i was hoping to change them back?

2 Accepted Solutions

Accepted Solutions

Hi David,

that should be quiet easy, please try this...

- Download the standalone IOS Image you want to use.

- Unplugged the power hold the mode button and put the power back on.

- Hold the mode button for at least 20 second.

- The AP now has an ip address of 10.0.0.1 and is looking for the file :
    ftp://255.255.255.255/c1240-k9w7-tar.default

   place a tftp server with the file in the subent 10.0.0.0/8 and the AP will automatically upload  the IOS file to the AP and after a automatic reboot of    the     AP and is back with an normal IOS

regards,

Sebastian

if that help, pls. rate..

View solution in original post

I prefer tftp32 (32bit) or 64(64bit) depends on your workstation or server.

After you start the tool it select your NIC and IP automatic.

Put the IOS file in the diectory you see there or choose the directory you want in the tool.

Disable your local firewall or open the necessary ports.

thats all, you will see after the startof tha tool, the tool is quiet easy.

regards,
Sebastian

View solution in original post

4 Replies 4

Hi David,

that should be quiet easy, please try this...

- Download the standalone IOS Image you want to use.

- Unplugged the power hold the mode button and put the power back on.

- Hold the mode button for at least 20 second.

- The AP now has an ip address of 10.0.0.1 and is looking for the file :
    ftp://255.255.255.255/c1240-k9w7-tar.default

   place a tftp server with the file in the subent 10.0.0.0/8 and the AP will automatically upload  the IOS file to the AP and after a automatic reboot of    the     AP and is back with an normal IOS

regards,

Sebastian

if that help, pls. rate..

Hey , can you give me a quick rundown on how to set up a  tftp server? i have downloaded the firmware i want to use. thank you

I prefer tftp32 (32bit) or 64(64bit) depends on your workstation or server.

After you start the tool it select your NIC and IP automatic.

Put the IOS file in the diectory you see there or choose the directory you want in the tool.

Disable your local firewall or open the necessary ports.

thats all, you will see after the startof tha tool, the tool is quiet easy.

regards,
Sebastian

Thank you very much, i googled it and used SolarWindsTFTPServer. thanks again

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: