cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
723
Views
0
Helpful
3
Replies

Mac ACL wont work on my C3560CX switch

757VA
Level 1
Level 1

this is odd to me, i use the same acl on my 3850 and 3650 switches and they it works but on my C3560cx switch it wont.

there is something i'm missing but got me what it is. 

my ios is 15.2(6)E1

here is my acl

mac access-list extended Samsung-VoIP
permit 00d0.5f00.0000 0000.00ff.ffff host 0000.0000.0000
permit f4d9.fb00.0000 0000.00ff.ffff host 0000.0000.0000
permit 0016.b700.0000 0000.00ff.ffff host 0000.0000.0000
permit 0021.4c00.0000 0000.00ff.ffff host 0000.0000.0000
permit 0016.3200.0000 0000.00ff.ffff host 0000.0000.0000
permit 000b.8200.0000 0000.00ff.ffff host 0000.0000.0000
permit 0009.4500.0000 0000.00ff.ffff host 0000.0000.0000
permit 18e8.0f00.0000 0000.00ff.ffff host 0000.0000.0000
permit 6416.7f00.0000 0000.00ff.ffff host 0000.0000.0000
permit 0004.f2ec.0000 0000.00ff.ffff host 0000.0000.0000
deny host 0000.0000.0000 host 0000.0000.0000
mac access-list extended X-VoIP-phones
deny 00d0.5f00.0000 0000.00ff.ffff host 0000.0000.0000
deny f4d9.fb00.0000 0000.00ff.ffff host 0000.0000.0000
deny 0016.b700.0000 0000.00ff.ffff host 0000.0000.0000
deny 0021.4c00.0000 0000.00ff.ffff host 0000.0000.0000
deny 0016.3200.0000 0000.00ff.ffff host 0000.0000.0000
deny 000b.8200.0000 0000.00ff.ffff host 0000.0000.0000
deny 0009.4500.0000 0000.00ff.ffff host 0000.0000.0000
deny 18e8.0f00.0000 0000.00ff.ffff host 0000.0000.0000
deny 6416.7f00.0000 0000.00ff.ffff host 0000.0000.0000
deny 0004.f2ec.0000 0000.00ff.ffff host 0000.0000.0000
permit host 0000.0000.0000 host 0000.0000.0000

 

am i just being a dope about this or is there an oolie i dont know for the c3560cx sw?

 

please advise

3 Replies 3

Hello

For one the 3560 switch are older than the 3650 and 3850, can you explain what isnt working?, Is the acl being taken or dismissed or is it that it just doesn't work?


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

The switch will take the acl, and save it off. when I implement the acl it will not do what it is set to do.

It is to allow only the mac address in the ranges specified and block all others. Instead it just blocks everything.


Review Cisco Networking for a $25 gift card