Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
910
Views
0
Helpful
1
Replies

MAC Sec [Switch to Switch]

Sergiy Pyvovaroff
Level 1
Level 1

‎06-02-2012 06:05 AM - edited ‎03-07-2019 07:02 AM

Hi All!

My question is about deploying MacSec over L2 MAN provider.

I have HQ office and some Big office linked via MAN provider VLAN(X). Same provider provides L3 MPLS service with other VLAN(Y) for low speed far shops and offices.  Can I use MACSEC on VLANX between Cat4507+E/Sup7L-E and Cat 3560X with Service Module, when traffic passes through the other switches, and network provider could?

Thanks  All!

Labels:
Preview file
77 KB
0 Helpful
1 Reply 1

hobbe
Level 7
Level 7

‎06-02-2012 06:28 AM

Hi

This is to my understanding not possible.

Since it is hop by hop you can not have another device between your endpoints.

(I am not sure what happens if you set a hub there.)

good luck

HTH

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card