03-11-2014 06:25 AM - edited 03-07-2019 06:38 PM
Dear All,
We are trying to enable Macsec (switch to host) on switchports but couldn't find following commands. We are running 15.0(2)se4 IPBASE image.
Both the above commands are not available. I was able to create the MKA policy on the switch in the global configuration mode.
As per below guide MACsec is supported on IPBase images, dont know why above commands are not there.
Regards,
Akhtar
03-11-2014 11:49 AM
The guide you are citing speaks to MACsec support on the 3750-X and 3560-X.
Your older 3750-G switch does not support MACsec due to hardware limitations. Please refer to the table on page 6 of the Trustsec Platform Support matrix.
03-12-2014 01:14 AM
We trying the same commands on 3750-x switch but its not available. Even we can't MKA policy command on it and we are running the ip base image. Any suggestions ?
Regards,
Akhtar
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide