07-30-2015 01:05 AM - edited 03-08-2019 01:10 AM
Hi all,
Just looking for some quick confirmation from the experts here:
I currently have a VSS setup with 2 4510's and SUP7-E modules running production.
The VSL link is connected via 2 TenGig interfaces on the Supervisor board.
We will have to perform maintenance on the all VSL link ports to replace SFP's.
I would like to perform the maintenance without disrupting the VSL/VSS setup.
Can I just shut the port I will be performing maintenance on, replace the SFP and no shut it to bring it up again without disruption on the VSS/VSL and then repeat the process until all 4 SFPs are replaced?
I do not care about a couple of dropped packets, we will perform the maintenance during a window. I do however want to keep the VSS running as is.
Solved! Go to Solution.
07-30-2015 05:12 AM
As long as one VSL link is up, it should not disrupt the set up.
How ever do it in a maintenance window.
Thanks,
Madhu.
07-30-2015 05:12 AM
As long as one VSL link is up, it should not disrupt the set up.
How ever do it in a maintenance window.
Thanks,
Madhu.
07-30-2015 06:10 AM
Thank you for your quick reply Madhu, greatly appreciated!
I would have thought so that no impact would be seen, but because it is the first time we will perform maintenance on our VSL, I want to better be safe than sorry.
Thanks again,
Colin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: