Manual Allocation of dsp in router

[esther.tan]

Hi

Can I do a manual allocation of the dsp resources in router?

1. If I have 3 PVDM, can I assign one PVDM solely for conference, one PVDM solely for transcoding?

2. Can I sub-divide a PVDM to split across differently functionalities, eg. conferencing use 1dsp, transcoding use another 1dsp out of the same PVDM?

My understanding is dsp is "automatically" assigned across the functionalities, like E1, conferencing, transcoding.

Please correct me if I am wrong.

Thanks

[Ganesh Hariharan]

Hi
Can I do a manual allocation of the dsp resources in router?
1. If I have 3 PVDM, can I assign one PVDM solely for conference, one PVDM solely for transcoding?
2.
Can I sub-divide a PVDM to split across differently functionalities,
eg. conferencing use 1dsp, transcoding use another 1dsp out of the same
PVDM?
My understanding is dsp is "automatically" assigned across the functionalities, like E1, conferencing, transcoding.
Please correct me if I am wrong.
Thanks

Hi,

Check out the below link hope that helps

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html#wp1003287

Ganesh.H

Remeber to rate the helpful post