I have a pair of 6500-13 VSS switches in production for campus core/distribution and I'm replacing them with a pair of 6880-X. The SVIs are the default gateways for the entire LAN. the configuration and the setup will be identical.
What is the best way to do this without IP address changes?
you can build the VSS on the 6880 in an isolated environment (without connecting it to the existing network) so there is no conflict, test it. Load the config from the old 6500 to the new 6800 and than in on outage window disconnect the cables from the old 6500 and connect them to new 6880.
the scenario is :I'm replacing core Cisco switch 4506-E with switch 4507R-E. As I have one supervisor card on 4506-E and I'm going to take out all the card that I have in 4506-E and install it in the new 4507R-E. On the 4507R-E I have 2 slots for the supe...
Since its release in August of 2019, the SASE report released by Gartner has generated a lot of chatter regarding what SASE is all about. People are wondering whether it will be disruptive to the current network and network security designs and are curiou...
I tried to setup a virtual environment with 2960 switches and 2911 Router. In one part of the network where I connected PCs directly to the 2911 Router, I was able to communicate to the attached devices, having configured static route. In the th...
Network Insider Live Webinar
Tuesday, June 23, 2020 10:00 am Pacific Time (San Francisco, GMT-08:00)
Learn how Software-Defined Access and new innovations in Cisco DNA Center provide a better way to control your network. We will explore new enhancements, ...
This event had place on Thursday 30, April 2020 at 10hrs PDT
Victor Moreno is a Distinguished Engineer at Cisco Systems responsible for the definition of next generation network architectures. Victor has over 20 years of i...