cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

352
Views
0
Helpful
0
Replies
Highlighted

Monitor Qos on cisco 6500

Hello ,  is someone have an idea about that ? i have configured c6509 with Qos (1p3q8t) for line card.

But when i use commands on c6509, it's impossible to verify packets in each file queue predefined. I can't identify if a packet is in

good file queue. I would like to check if Qos policy is correctly applied .

- sh queueing interface gigabitEthernet 1/2/1 detailed

  Packets dropped on Transmit:

    BPDU packets:  0

    que           dropped        30-s bytes        peak bytes    5-mins avg bps          peak bps  [cos-map]

    ---------------------------------------------------------------------------------------------------


    1                   0                 0                 0                 0                 0   [1 ]

    2                   0                 0                 0                 0                 0   [0 ]

    3                   0                 0                 0                 0                 0   [4 2 3 6 7 ]

    4                   0                 0                 0                 0                 0   [5 ]


  Packets dropped on Receive:

    BPDU packets:  0

    que           dropped        30-s bytes        peak bytes    5-mins avg bps          peak bps  [cos-map]

    ----------------------------------------------------------------------------------------------------

    1                   0                 0                 0                 0                 0   [0 1 2 3 4 5 6 7 ]


====>>> there is only dropped packets with these commands, i would like to be able to count the number of packets going tru each Q ? Is it possible to do that ?


                                             

Everyone's tags (4)
CreatePlease to create content
Content for Community-Ad