01-02-2009 09:12 PM - edited 03-06-2019 03:14 AM
Hi guys,
Is there any way on how to manually monitor error in switches (like loops, interface down, CPU usage, bandwidth usage)? using only commands in switch/router. Thanks.
Cheers!
Solved! Go to Solution.
01-04-2009 09:52 AM
Hi,
the best command to use is #Show Process [memory] or [CPU]. These 2 options give you a lot of details.
You can also use #Show process CPU history. This will give a graph over last 60 minutes, few hours etc.
Hope This Helps...
Shaheen
01-04-2009 07:15 AM
there is no single command to show all details
thanks
01-04-2009 09:52 AM
Hi,
the best command to use is #Show Process [memory] or [CPU]. These 2 options give you a lot of details.
You can also use #Show process CPU history. This will give a graph over last 60 minutes, few hours etc.
Hope This Helps...
Shaheen
01-05-2009 12:20 AM
Hello Guys Thanks. Yes, there is no one command but show process will help a lot. :-)
Thanks again.
Cheers!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide