MTU Size in Cisco SG-350 SFP -28 Switch

[TechDog01170]

Hi Friends

I was trying to change MTU size in Cisco SG-350-28SFP switch. The command Switch(config)# system mtu 2500  is not working. This command is not available. I want to change the MTU size from 1500 to 1600. Can anyone help how we can do this?

Regards

T

[Joseph W. Doherty]

Assuming the switch supports jumbo Ethernet frames, it might only support one jumbo size.

What does "system mtu ?" show?

[TechDog01170]

system mtu says command is not available

[Reza Sharifi]

Hi,

try this command:

 port jumbo-frame 

HTH

[TechDog01170]

I will do that. Are enabling jumbo frames and increasing MTU size same?

[Reza Sharifi]

Yes. That is correct. You can have different MTU sizes and jumbo is usually the highest (9216) if the device support it

HTH