multi layer switch - cisco packet tracer

[gl94]

I am not able to ping any switch from router 3. How do i set up default-gateway for this switch ( not the default-network)

[Diana Karolina Rojas]

Are you using this switch as a Layer 2 or Layer 3 device? do you have routes and SVIs configured in your switches? 

Regards,

[gl94]

layer 2.
but the issues is solved.i had given "no ip routing" command previously.

Thanks for your help though.

[Julio E. Moisa]

Hi

Could you please share your configuration?, are you using any routing protocol? The default-gateway can be configured using: ip default-gateway <Gateway IP of your management Vlan>, it is useful to enable the access for remote access through vty lines. 

[gl94]

Yes, I am using OSPF.
The issues is solved, I realized that I have disabled the routing by "no ip routing" command ( was following the tutorial :p).

But thanks for help though.

[Julio E. Moisa]

Hi,

Good to know

Have a great day

:-)