I want to set up Multicast with multiple Auto RP. I Basically have two RP that need to be able to multicast information to all of my routers. Can i do this and use ip pim sparse-mode or does it have to be sparse-dence mode? I dont want to set up access groups becuase all routers and vlan's need access to both RP's.
The AutoRP itself depends on the dense mode, so in common deployments with AutoRP, the sparse-dense is a must. However, you may work this around by using only sparse-mode and configuring ip pim autorp listener global configuration command on all your multicast routers. This command allows to propagate the AutoRP multicast traffic (220.127.116.11 and 18.104.22.168) over sparse-mode interfaces as if they were configured for sparse-dense mode.
Inviting all network professionals in operations! We'd like to understand what would be valuable for you in a mobile application. Your response will help Cisco improve a product feature that could benefit you. Thanks!
Click here to take the sur...
Cisco’s software-defined wide area network (SD-WAN) solution allows user to quickly and seamlessly establish an overlay fabric to connect an enterprise’s data centers, branch and campus locations, as well as colocation facilities in order to imp...
1. Log into CLI of DNAC:
ssh maglev@< DNAC appliance IP> -p 2222
2. Run this curl command to get token to get member id:
curl -X POST -u admin:<admin user password> -H -V https://<CLUSTER-IP>/api/system/v1/identitymgmt/token
Enterprise Switching Business Unit is glad to announce Beta release 16.12.2 for all Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms. This release is made available to allow users to test, evaluate and share fee...
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...