03-24-2015 02:10 AM - edited 03-07-2019 11:13 PM
Good Morning all,
I would like some help with a switchport config on one of my VMware clusters.
Currently the live vDS sits with the below config on a Cisco 4500
switchport trunk encapsulation dot1q
switchport trunk native vlan 8
switchport mode trunk
spanning-tree portfast trunk
spanning-tree bpduguard enable
I require the hots to be able to communicate on multiple VLANs, it sits on VLAN 8 but needs to communicate on 200 and 201 and 8.
Any help would be greatly appreciated.
Thanks,
Hassan.
03-24-2015 04:59 AM
You already have it setup as a trunk and nothing is pruned off so by default all vlans are allowed across the trunk . It should work as configured , if not check the server side.
03-24-2015 05:03 AM
Hassan
The switch port that you show us is correctly configured as a trunk. You have not shown us whether these three vlans are correctly configured on the switch and active on the interface. The output of show interface trunk would be helpful in determining this. If the switch appears to be correctly configured then the other part of the question is whether your VMware cluster is correctly configured to use the three vlans on that interface.
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: