n3k Bootflash Problem after Upgrade

[admin@atrinnet.net]

Nexus 3000 after upgrade , go to loader mode

1-cmdline recoverymode=1

2-boot usb1:/n3000-uk9-kickstart.6.0.2.U3.8.bin

after initial

format bootflash:

mke2fs 1.35 (28-Feb-2004)
mke2fs: No such device or address while trying to determine filesystem size
Formatting finished at: Wed May 15 15:14:55 UTC 2024
mount: /dev/sdb3 is not a valid block device
Formatting completed

Cannot Format bootflash:

Follow this link

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/6-x/troubleshooting/guide/b_Cisco_Nexus_9000_Series_NX-OS_Troubleshooting_Guide/b_Cisco_Standalone_Series_NX-OS_Troubleshooting_Guide_chapter_01.html

But but flash not formated that copy on bootflash nxos

[marce1000]

 - Try the command mentioned in https://www.cisco.com/c/en/us/support/docs/switches/nexus-3500-series-switches/116699-technote-product-00.html#anc7

 M.

[admin@atrinnet.net]

I am in Loader mode

[balaji.bandi]

make sure you are in right prompt while formatting 

check below thread :

https://community.cisco.com/t5/switching/nexus-3k-problem-bootflash-formatting/td-p/5105122

[admin@atrinnet.net]

How exit uncompress system

switch(boot)#" ????

Used

cmdline recoverymode=1

But not allowded format bootflash

[balaji.bandi]

you can not exit from that, you need get full # (as i mentioned other thread)

[admin@atrinnet.net]

So i used this

cmdline recoverymode=1

in loader mode and boot by usb1:/kisktart

But still in switch(boot)#

How solve this ?