I tried to use a 1G SFP on the N7710 F3 module. But kept getting "Transceiver speed does not match the speed configured on the port" message.
Is there any tricks on that? e.g. do I have to configure the port speed / plug in the SPF in specific order? Thanks!
interface Ethernet1/42 speed 1000
Ethernet1/42 is down (Transceiver speed does not match the speed configured on the port) admin state is down, Dedicated Interface Hardware: 1000/10000 Ethernet, address: 002a.6a8c.9541 (bia 544a.00ad.59a5)
Hi Guys, I have two questions about EIGRP behavior when we have Multiple EIGRP routes: 1- I tried to show on some router the acquired EIGRP paths for a route X.X.X.X by typing the command : "show ip eigrp topology X.X.X.X". On the output there w...
[ The Discussion forum will be published on December 1st ]
Take the opportunity to reach out to our expert and discuss best practices regarding on how to troubleshoot a live network and identify the root cause easily. Learn more about Serviceability and h...
To provide a solution to quickly setup a router at a remote location that supports WiFi and provides instant internet access using LTE as a transport while deploying with Cisco SD-WAN.
Plug the router to a power sou...
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...