Need help with l3 intervlan routing

[mzumarawongani57]

I want to route between vlans using layer 3 switches and also route from the vlan to router 0

So i have configured the vlans on sw1 and sw2, i have also configured SVI for all vlans on L3 switches

i have enabled routing already, trunk have been configured

but when i check the routing table only int vlan 1 appears

how can i configure this ?

Help! thank you

[paul.driver]

Hello

Is this a packet tracer lab, if so can you attach this labs file.

[paul driver]

Is this a packet tracer lab, if so can you attach this labs file.

EDITED -Please  ignore the post below - Cisco are doing something with my profile and for some temporary time i lost all my posts for the passed 10 years! I didn't realize until I replied to your post .

[Martin L]

check L3 SVI state UP? with show ip interface brief command.   is it UP UP?

you may need a host for vlan x to bring SVI x to UP/UP state.  Note that PT does not have auto-state exclude command that would let us keep SVI UP while there are no hosts connected to vlan / switch or hosts are down (turned off).

Also, double check vlans are present in the vlan database and allowed on trunks.

Regards, ML
**Please Rate All Helpful Responses **