netflow top-talker 4500x IOS 3.8.4.e

[Deepak Kumar]

Dear All,

I am missing something but what is it? Not getting any idea. I am configuring Netflow 9 and I am not getting top-talker on the prtg. 

flow record frPrtg
description Prtg
match ipv4 tos
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port
match interface input
collect transport tcp flags
collect counter bytes
collect counter packets
collect timestamp sys-uptime first
collect timestamp sys-uptime last

!

flow exporter fePrtg-1
description WAN-traffic--Prtg
destination x.x.x.x
source Vlanxx
transport udp 9993
template data timeout 1200
option interface-table timeout 3600
option exporter-stats timeout 60

!

flow monitor fmPrtg-1
description WAN-traffic-Prtg
exporter fePrtg-1
cache timeout active 60
record frPrtg
!

can you guide me if I am missing anything?

[Reza Sharifi · Accepted solution]

Hi,

Have you added "ip flow monitor ....input and output to the interfaces?

Also, you may want to add these and test again:

collect counter bytes long
collect counter packets long
collect counter bytes rate

HTH

[balaji.bandi]

flow exporter fePrtg-1
description WAN-traffic--Prtg
destination x.x.x.x
source Vlanxx
no transport udp 9993   < is this configured other side (or try port below to work)

transport udp 2055
export-protocol netflow-v9

interface te 1/1/1
ip flow monitor XXXXXXXXX input

[Deepak Kumar · Accepted solution]

Thanks for the reply. I really appreciate your support. 

It was an issue with the PRTG team and the sensor was not enabled properly.  Thanks again.

[Reza Sharifi]

Thanks for the feedback!

Glad to know the issue has been resolved.

Reza