cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
206
Views
0
Helpful
3
Replies
Highlighted

Network Migration

 

 

How to do a network Design 

step by step (Best practice)

 

    Site 1                                            ( HA     )                                 Site2

 Core switch-1              --------   500m  --------------      Core switch 2                    

 

                                           

                            DistributionSWs Connect site1&site2(coreSWs)                                 

Distribution SW1     |                                                             |  Distribution SW1

Distribution SW2     |                                                             |  Distribution SW2

Distribution SW3     |                                                             | Distribution SW3

Distribution SW4     |                                                             | Distribution SW4

                                                          

 

                                       Site-1                        Site-2

                                           ACCESS SWITCHES

 

Q1)How to connect core switches as HA

Q2)How to connect Distribution switches connect to site1 and site2 core switches it possible?

 

 

Please advise me to give the best solution 

Thank you.

 

 

Everyone's tags (1)
3 REPLIES 3
Highlighted
Hall of Fame Community Legend

Re: Network Migration

If you don't know what you're doing then get a reputable integrator to do it, otherwise, it will be a very costly affair.
Highlighted
VIP Mentor

Re: Network Migration

As @Leo Laohoo suggested get a consultant if you are not sure.

 

or

I have Many questions required to answer here 

 

1. What model of  Core Switch? VSS? single Core Switch?

2. how many supervisors in each core?

3. is this Layer 2 or Layer3

4. what IGP process running

 

In terms of High availability or resilience?

 

Are you looking at the Core level or distribution level?

Do you have enough ports available in the core or distribution to make it mesh setup?

500M Means you need to go single-mode Fibre ? is this inside your campus?

 

BB
*** Rate All Helpful Responses ***
Highlighted
Hall of Fame Master

Re: Network Migration

Hello @leyakhath muhammed ,

 

>> Q2)How to connect Distribution switches connect to site1 and site2 core switches it possible?

This is possible if appropriate cabling is installed in the campus you will need at least 2+4+4 = 10 pairs of single mode fibers and you need also to provide two additional pairs for redundancy or future growth.

 

>> Q1)How to connect core switches as HA

You can use fiber based links 2 x 10GE to build a VSS or SVL pair. This will make the core switches to appear as a single device to the outer world.

 

Hope to help

Giuseppe

 

 

 

Content for Community-Ad