10-08-2012 05:18 AM - edited 03-07-2019 09:20 AM
Hi all,
on some of our ports on Nexu 5000 and on the connected FEX we can see a lot of Jumbo Packets though there is not enableed any JumboFrame on the Switch, all Interface and system MTU is set to 1500.
Any idea what the reason could be ?
DBE-LINZ-XX41# sh int Eth113/1/27
Ethernet113/1/27 is up
Hardware: 100/1000 Ethernet, address: d0d0.fd1b.b69c (bia d0d0.fd1b.b69c)
Description: LNZTSM01
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec
reliability 255/255, txload 23/255, rxload 1/255
Encapsulation ARPA
Port mode is access
full-duplex, 1000 Mb/s
Beacon is turned off
Input flow-control is off, output flow-control is on
Switchport monitor is off
EtherType is 0x8100
Last link flapped 6d05h
Last clearing of "show interface" counters never
30 seconds input rate 852552 bits/sec, 1663 packets/sec
30 seconds output rate 64087584 bits/sec, 5407 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 1.02 Mbps, 1.96 Kpps; output rate 91.23 Mbps, 7.69 Kpps
RX
2485768492 unicast packets 584586 multicast packets 204506 broadcast packets
2486557584 input packets 316104351138 bytes
46589374 jumbo packets 0 storm suppression packets
0 runts 0 giants 0 CRC 0 no buffer
0 input error 0 short frame 0 overrun 0 underrun 0 ignored
0 watchdog 0 bad etype drop 0 bad proto drop 0 if down drop
0 input with dribble 0 input discard
0 Rx pause
TX
15585478160 unicast packets 3257120 multicast packets 9075777 broadcast packets
15597811058 output packets 22869193087701 bytes
16174552 jumbo packets
1 output errors 0 collision 0 deferred 0 late collision
0 lost carrier 0 no carrier 0 babble 0 output discard
0 Tx pause
3 interface resets
DBE-LINZ-XX41#
DBE-LINZ-XX41# sh int Eth113/1/27 counters trunk
--------------------------------------------------------------------------------
Port TrunkFramesTx TrunkFramesRx WrongEncap
--------------------------------------------------------------------------------
Eth113/1/27 241207284 132894381 0
DBE-LINZ-XX41# sh int Eth113/1/27 counters errors
--------------------------------------------------------------------------------
Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize OutDiscards
--------------------------------------------------------------------------------
Eth113/1/27 0 0 0 0 0 0
--------------------------------------------------------------------------------
Port Single-Col Multi-Col Late-Col Exces-Col Carri-Sen Runts
--------------------------------------------------------------------------------
Eth113/1/27 0 0 0 0 0 0
--------------------------------------------------------------------------------
Port Giants SQETest-Err Deferred-Tx IntMacTx-Er IntMacRx-Er Symbol-Err
--------------------------------------------------------------------------------
Eth113/1/27 0 -- 0 0 0 0
DBE-LINZ-XX41# sh int Eth113/1/27 counters storm-control
--------------------------------------------------------------------------------
Port UcastSupp % McastSupp % BcastSupp % TotalSuppDiscards
--------------------------------------------------------------------------------
Eth113/1/27 100.00 100.00 100.00 0
DBE-LINZ-XX41# sh int Eth113/1/27 counters detailed
Ethernet113/1/27
Rx Packets: 2486518514
Rx Unicast Packets: 2485729448
Rx Multicast Packets: 584561
Rx Broadcast Packets: 204505
Rx Jumbo Packets: 46589374
Rx Bytes: 316101848567
Rx Packets from 0 to 64 bytes: 1773531487
Rx Packets from 65 to 127 bytes: 567547819
Rx Packets from 128 to 255 bytes: 20043087
Rx Packets from 256 to 511 bytes: 19417196
Rx Packets from 512 to 1023 bytes: 7292742
Rx Packets from 1024 to 1518 bytes: 52096809
Rx Trunk Packets: 132894381
Tx Packets: 15597681912
Tx Unicast Packets: 15585349564
Tx Multicast Packets: 3257037
Tx Broadcast Packets: 9075310
Tx Jumbo Packets: 16174552
Tx Bytes: 22869001813057
Tx Packets from 0 to 64 bytes: 34480870
Tx Packets from 65 to 127 bytes: 193872533
Tx Packets from 128 to 255 bytes: 54037447
Tx Packets from 256 to 511 bytes: 87243119
Tx Packets from 512 to 1023 bytes: 335063194
Tx Packets from 1024 to 1518 bytes: 14876810197
Tx Trunk Packets: 241207284
Output Errors: 1
DBE-LINZ-XX41# sh int Eth113/1/27
Ethernet113/1/27 is up
Hardware: 100/1000 Ethernet, address: d0d0.fd1b.b69c (bia d0d0.fd1b.b69c)
Description: LNZTSM01
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec
reliability 255/255, txload 23/255, rxload 1/255
Encapsulation ARPA
Port mode is access
full-duplex, 1000 Mb/s
Beacon is turned off
Input flow-control is off, output flow-control is on
Switchport monitor is off
EtherType is 0x8100
Last link flapped 6d05h
Last clearing of "show interface" counters never
30 seconds input rate 852552 bits/sec, 1663 packets/sec
30 seconds output rate 64087584 bits/sec, 5407 packets/sec
Load-Interval #2: 5 minute (300 seconds)
input rate 1.02 Mbps, 1.96 Kpps; output rate 91.23 Mbps, 7.69 Kpps
RX
2485768492 unicast packets 584586 multicast packets 204506 broadcast packets
2486557584 input packets 316104351138 bytes
46589374 jumbo packets 0 storm suppression packets
0 runts 0 giants 0 CRC 0 no buffer
0 input error 0 short frame 0 overrun 0 underrun 0 ignored
0 watchdog 0 bad etype drop 0 bad proto drop 0 if down drop
0 input with dribble 0 input discard
0 Rx pause
TX
15585478160 unicast packets 3257120 multicast packets 9075777 broadcast packets
15597811058 output packets 22869193087701 bytes
16174552 jumbo packets
1 output errors 0 collision 0 deferred 0 late collision
0 lost carrier 0 no carrier 0 babble 0 output discard
0 Tx pause
3 interface resets
DBE-LINZ-XX41#
10-08-2012 11:02 AM
Hi,
The way you can verify to see if jumbo frame size in enabled on the 5k is by issuing command "sh queu interface e113/1/27"
The command sh interface e113/1/27" does not tell you if you have jumbo frame enabled or not.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: