07-04-2013 04:40 AM - edited 03-07-2019 02:14 PM
Is it possible at nexus 5548 with daughter card to assign ipv6 address to interface?
I have gone thru lot's od docs cisco says on tech doc:
• IPv6 Routing Protocols: Static, Open Shortest Path First Version 3 (OPFv3), Border Gateway Protocol (BGPv6), Enhanced Interior Gateway Routing Protocol (EIGRPv6)
• IPv6 VRF Lite
So I am assuming is supporting IPv6 routing.
command line:
NEXUS-1(config-if)# ipv6 add?
^
% Invalid command at '^' marker.
?
^
% Invalid command at '^' marker.
NEXUS-1(config-if)# ipv6 ?
port Port policy
I was looking for feature to turn on but doesn't looks there is one.
Doesn't seem that I can turn it on by ipv6 unicast-routing.
Solved! Go to Solution.
07-04-2013 06:33 AM
Marcin,
Nope ipv6 is not supported on 5.1(3)N2(1) i.
Were as it is supported on 5.2 release.
Table 3-5 lists the release history for this feature.
Feature Name | Releases | Feature Information |
---|---|---|
IPv6 | 5.2(1) | This feature was introduced. |
HTH
Regards
Inayath
'***********
Please rate and mark the post as answered so others can benefit from it.
07-04-2013 04:45 AM
It might be something to do with your version of NX-OS.
Don't forget to rate all helpful posts.
07-04-2013 06:14 AM
My NX-OS is 5.1(3)N2(1) is that one supporting ipv6?
Is quite weird that nexus doesn’t support ipv6 where there is no many ipv4 left.
CISCO should really sort that out, we have spent over £50k for switches and we are not able to do dual stack ;(
07-04-2013 06:33 AM
Marcin,
Nope ipv6 is not supported on 5.1(3)N2(1) i.
Were as it is supported on 5.2 release.
Table 3-5 lists the release history for this feature.
Feature Name | Releases | Feature Information |
---|---|---|
IPv6 | 5.2(1) | This feature was introduced. |
HTH
Regards
Inayath
'***********
Please rate and mark the post as answered so others can benefit from it.
07-04-2013 06:40 AM
Does it mean that we have to buy new NX OS update for brand new switches?
We have received those switches with this software yesterday.
Or do I need to buy ASR to do IPv6 routing?
thanks
07-04-2013 07:12 AM
Marcin,
Just go ahed and upgrade the firmware.
Regards
Inayath
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: