cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1083
Views
0
Helpful
0
Replies
Highlighted
Beginner

Nexus 5548 rate limit

Hello,

I am trying to setup a rate limit on fex ports (modl is N2K-C2248TP-1GE ) of a 5548UP (non L3)  -  Software version is : version 6.0(2)N2(2)

I have tried the following setup without success  :

ip access-list ACL_CUST

  10 permit ip 10.100.100.1/32 10.100.100.2/32

  20 permit ip 10.100.100.2/32 10.100.100.1/32

class-map type qos match-all CMQOS_CUST

  match access-group name ACL_CUST

policy-map type qos PMQOS_CUST

class CMQOS_CUST

    police cir percent 1 bc 200 ms conform transmit violate drop

interface Ethernet161/1/11 - 12

  service-policy type qos input PMQOS_CUST

And also tried to use this confioguration :

class-map type qos match-all CMQOS_LIMIT_BP_CUST

  match cos 0-7

policy-map type qos PMQOS_LIMIT_BP_CUST

  class CMQOS_LIMIT_BP_CUST

    police cir percent 1 bc 200 ms conform transmit violate drop

interface Ethernet161/1/11 - 12

  service-policy type qos input PMQOS_LIMIT_BP_CUST

The problem is that the bandwith restriction (1 percent of 1Gbit/s shoud be 10Mbit/s) is not working and apparently no restriction is applied

If someone could help me to resolve this issue it would be greatly appreciated

I do have followed this guide

http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/qos/503_n1_1/cisco_nexus_5000_qos_config_gd_503_chapter3.html

Thanks !

0 REPLIES 0
Content for Community-Ad