cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
519
Views
10
Helpful
5
Replies
Beginner

Nexus 5548 vlan 4040

Hi, i found on my switch vlan 4040, mac address vlan 4040 cross with my active int-vlan interface. But i can't found in configuration where is vlan 4040 use. What is vlan 4040 ? 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

there the reserved vlan range

there the reserved vlan range for nx-os

3968 to 4047 and 4094

Internally allocated

These 80 VLANs and VLAN 4094 are allocated for internal device use. You cannot create, delete, or modify any VLANs within the block reserved for internal use.

does it show up in your show vlan or show int trunk anywhere ?

system maybe using it for something

View solution in original post

5 REPLIES 5
Highlighted
VIP Mentor

there the reserved vlan range

there the reserved vlan range for nx-os

3968 to 4047 and 4094

Internally allocated

These 80 VLANs and VLAN 4094 are allocated for internal device use. You cannot create, delete, or modify any VLANs within the block reserved for internal use.

does it show up in your show vlan or show int trunk anywhere ?

system maybe using it for something

View solution in original post

Highlighted
Beginner

Thank you for you answer.

Thank you for you answer.

I see this vlan only in command "sh mac adress table". Any else i can't found him. Mac address cross with active vlan:

# sh mac address-table address 002a.6xx.xxxx
Legend:
* - primary entry, G - Gateway MAC, (R) - Routed MAC, O - Overlay MAC
age - seconds since last seen,+ - primary entry using vPC Peer-Link
VLAN MAC Address Type age Secure NTFY Ports/SWID.SSID.LID
---------+-----------------+--------+---------+------+----+------------------
* 802 002a.xxxx.xxxx static 0 F F Router
* 4040 002a.xxxx.xxxx static 0 F F Router

Highlighted
VIP Mentor

that's a cisco internal

that's a cisco internal static system mac im pretty sure as its 002a check the mac here ---https://macvendors.com/

Highlighted
Beginner

yes. This mac owned interface

yes. This mac owned interface vlan 802. 

Highlighted
Beginner

I see that same VLAN (4040)

I see that same VLAN (4040) but I see it in the "sh vpc consistency-parameters global" output under the "Allowed VLANs" section. It is on one side of the vPC but not the other and i think that is what is causing the Type 2 inconsistency status.

Type-2 consistency status              : failed
Type-2 inconsistency reason            : SVI type-2 configuration incompatible

I realize the "reason " states 'SVI config incompatible" but all of my SVI's are consistent across the two vdc's. Could this mystery VLAN be causing the Type 2 inconsistency?

CreatePlease to create content
Content for Community-Ad