10-18-2012 09:41 AM - edited 03-07-2019 09:33 AM
we installed copper and fiber sfp modules in the 2232PP and none would link up. we pulled the sfp modules out and entered the speed 1000 command and re-inserted the module with no success. the same sfp modules works fine in every other cisco device. we must be missing something. running latest nx-os software.
COH-Nexus-02# sh int Eth101/1/1 status
--------------------------------------------------------------------------------
Port Name Status Vlan Duplex Speed Type
--------------------------------------------------------------------------------
Eth101/1/1 -- unknown e 40 full 1000 --
COH-Nexus-02#
COH-Nexus-02# sh int Eth101/1/1 transceiver det
Ethernet101/1/1
transceiver is present
type is 1000base-T
name is CISCO-METHODE
part number is SP7041_Rev_F
revision is F
serial number is 00000MTC16240871
nominal bitrate is 1300 MBit/sec
Link length supported for copper is 100 m
cisco id is --
cisco extended id number is 4
DOM is not supported
COH-Nexus-02#
10-18-2012 11:03 AM
What is Ethernet101/1/1 connected to?
10-18-2012 11:12 AM
please disregard, the fabric extender is 10ge only. thanks.
10-18-2012 01:09 PM
THESE ARE THE TRANSCEIVERS SUPPORTED ON THE FEX 2232PP :
• 1/10 Gigabit Ethernet ports SFP/SFP+ (Supported transceiver and cables include Twinax SFP-H10GB-CU1M, SFP-H10GB-CU3M, SFP-H10GB-CU5M, SFP-H10GB-ACU7M, and SFP-H10GB-ACU10M, include SFP+ SFP-10G-SR, SFP-10G-LR, and include SFP GLC-T, GLC-SX-MM, GLC-LH-SM, SFP-GE-T, SFP-GE-S, SFP-GE-L)
---
Posted by WebUser Adil Taleb from Cisco Support Community App
10-18-2012 01:10 PM
Is the 5548UP have the LAN BASE licences installed on?
---
Posted by WebUser Adil Taleb from Cisco Support Community App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: