Nexus 7000 module powered-dn status

[John Pong]

Hi All,

One of our Nexus 7000 modules failed and generated the status below. Could this possibly be a hardware issue?

# show module

Mod  Ports  Module-Type                         Model              Status

---  -----  ----------------------------------- ------------------ ----------

1    0      10 Gbps Ethernet XL Module                             powered-dn

  Mod  Power-Status  Reason

---  ------------  ---------------------------

1    powered-dn     Unable to power up card (Power_OK not set)

Thanks!

[Leo Laohoo]

Could be powered down because your N7K is running an un-supported version of OS.

[InayathUlla Sharieff]

John,

Per the information, the recommendation would be

doing the following:

1. diagnostic bootup level complete

2. Reseat module 1

3. show diagnostic result module 1

4. show module

If you still face the same issue after reseating it then RMA the module.

HTH

Regards

Inayath

[John Pong]

Thanks Inayath for the inputs. I tried to  the "diagnostic bootup level complete" command however I was not able to input the command.

[InayathUlla Sharieff]

Try this:

Nexus(config)# diagnostic bootup level complete

REgards

Inayath

*Plz rate all usefull posts,.

[deepak george]

Dear Inayath,

Please advise if GOLD is disruptive or non disruptive.