Nexus 7k SUP2 "Show Mac Address-table" doesnt display dynamic MACs
I am currently logged in to a VDC on a 7009 nexus switch. I have vdc-admin role. When I enter "show mac address-table" only the supervisor MAC in each VLAN is displayed and no dynamically learned MACs are displayed.
Is this right?
I was expecting to see dynamic MACs for this particular VDC.
its worth mentioning that we are running FabricPath on this switch.
I can get dynamic MACs if I specify a specific module... but the learned interface for each MAC is not the traditional "ethx/x"...
xxxxxx# show mac address-table 4 Legend: * - primary entry, G - Gateway MAC, (R) - Routed MAC, (d) - dec Age - seconds since last seen,,+ - primary entry using vPC Peer-Link (T) - True, (F) - False, h - hex, d - decimal
VDC = 3
FE VLAN/BD MAC Address Type Age Secure NTFY Ports -----+------+-------------+--------+------+------+------+--------------- G 0 - xxxx.xxxx.xxxx static - F F sup-eth1 (R) 0 8 yyyy.yyyy.yyyy dynamic 30 F F gpc1:3564 0 28 zzzz.zzzz.zzzz dynamic 30 F F gpc1:2001
Listen: https://smarturl.it/CCRS9E25 Follow us: twitter.com/ciscochampions
With applications and users everywhere, the networks are now, more than ever, being tasked with delivering consistent protection while providing an exceptional user exper...
Listen: https://smarturl.it/CCRS9E24 Follow us: https://twitter.com/CiscoChampion
Cisco Radio Aware Routing addresses several of the challenges faced when merging IP routing and radio communications in mobile networks, especially those exhibiti...
Listen: https://smarturl.it/CCRS9E23 Follow us: https://twitter.com/CiscoChampion The Wi-Fi 6E Catalyst 9136 access point takes advantage of the 6-GHz band to produce a network that is more reliable and secure, with higher throughput, more ...
When moving from OSPFv2 to OSPFv3, there are many changes in the format of the LSAs Type, but the most known changes are: IP prefix informations are no longer carried in Type-1 LSA and Type-2 LSA, new LSAs Type 8 and 9 are added to carry these prefixes.