11-10-2012 08:36 PM - edited 03-07-2019 09:59 AM
Hello,
We have Nexus 7K recently installed few months back with 2 Sup (Slot 5 & Slot 6).
Recently recevied mesaanges in monitoring server via SNMP:
Alarm : active unit removal caused an auto SWACT
However, when checked there are no recent logs which may be linked to this alarm.
The show redundancy command output shows that Sup in slot 5 is active which in slot 6 is Hot Standby.
Please suggest if this is something serious & how to resolve this.
Thanks,
Nitin
Solved! Go to Solution.
11-11-2012 02:29 AM
Hi Nitin,
This is looks like trap massge which indicates any supervisor related activities any switchover / insertion / removal. Could you verify any recent supervisor switch over happend recently. Please verify below commands,
show version
show redundancy status
show system redundancy status
show system reset-reason module #
show logging nvram
show logging last 200
How often do you see this message?
Regards,
Aru
*** Please rate if the post is useful ***
11-11-2012 02:29 AM
Hi Nitin,
This is looks like trap massge which indicates any supervisor related activities any switchover / insertion / removal. Could you verify any recent supervisor switch over happend recently. Please verify below commands,
show version
show redundancy status
show system redundancy status
show system reset-reason module #
show logging nvram
show logging last 200
How often do you see this message?
Regards,
Aru
*** Please rate if the post is useful ***
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: