Hi All,
anyone knows if VRRP is supported in two addresses way with vPC configuration?
On Cisco Site i can see VRRP/vPC support but with this configuration (apart subnet errors...)
http://www.cisco.com/en/US/docs/switches/datacenter/sw/5_x/nx-os/unicast/configuration/guide/l3_vrrp.html#wp1129244
The Point is that i wanna use same address for virtual and one phy (one RFC_3768 way)
CISCO EXAMPLE
RouterA
interface ethernet 1/0
ip address 10.1.0.2/16
no shutdown
vrrp 1
priority 120
authentication text cisco
advertisement-interval 3
address 10.1.0.10
no shutdown
RouterB
interface ethernet 1/0
ip address 10.1.0.1/16
no shutdown
vrrp 1
priority 100
authentication text cisco
advertisement-interval 3
address 10.2.0.10
no shutdown
INSTEAD I WANNA CONFIGURE
RouterA
interface ethernet 1/0
ip address 10.1.0.2/16
no shutdown
vrrp 1
priority 120
authentication text cisco
advertisement-interval 3
address 10.1.0.2
no shutdown
RouterB
interface ethernet 1/0
ip address 10.1.0.1/16
no shutdown
vrrp 1
priority 100
authentication text cisco
advertisement-interval 3
address 10.1.0.2
no shutdown
tnx a lot
Dan