Same problem here on 9372PX. What's odd is that tab completion works for the commands and they show in help.
(config-if)# switchport ? <CR> access Set access mode characteristics of the interface block Block specified outbound traffic for all VLANs dot1q Configure dot1q EtherType value host Set port host isolated Disable loop-free detection. mode Enter the port mode monitor Configures an interface as span-destination port-security Port security related command trunk Configure trunking parameters on an interface vlan Set VLAN translation mapping
(config-if)# switchport port-security ? aging Port-security aging commands mac-address MAC address maximum Max secure addresses violation Security violation mode
Listen: https://smarturl.it/CCRS9E25 Follow us: twitter.com/ciscochampions
With applications and users everywhere, the networks are now, more than ever, being tasked with delivering consistent protection while providing an exceptional user exper...
Listen: https://smarturl.it/CCRS9E24 Follow us: https://twitter.com/CiscoChampion
Cisco Radio Aware Routing addresses several of the challenges faced when merging IP routing and radio communications in mobile networks, especially those exhibiti...
Listen: https://smarturl.it/CCRS9E23 Follow us: https://twitter.com/CiscoChampion The Wi-Fi 6E Catalyst 9136 access point takes advantage of the 6-GHz band to produce a network that is more reliable and secure, with higher throughput, more ...
When moving from OSPFv2 to OSPFv3, there are many changes in the format of the LSAs Type, but the most known changes are: IP prefix informations are no longer carried in Type-1 LSA and Type-2 LSA, new LSAs Type 8 and 9 are added to carry these prefixes.