Nexus 9396PX and port-security

[schwarzenbachcyb]

Is it possible, that the Cisco Nexus 9000 Series (specially the 9396PX) doesn't support port-security?

Nexus9k(config-if)# switchport port-security aging time 10
Service not enabled

There is also no feature with this name:

Nexus9k# sh feature | grep secur
Nexus9k# sh feature | grep port
Nexus9k#

If this feature is not supported on the Nexus 9396PX, is there another way to configure a max-mac-address-per-interface policy?

Edit: The Nexus is running NX-OS 7.0(3)I2(2a)

[jmeggers]

I'm looking for this also but I haven't found any evidence the Nexus 9300 series supports port security.

[ted.schwind]

Same problem here on 9372PX. What's odd is that tab completion works for the commands and they show in help.

(config-if)# switchport ?
<CR>
access        Set access mode characteristics of the interface
block         Block specified outbound traffic for all VLANs
dot1q         Configure dot1q EtherType value
host          Set port host
isolated      Disable loop-free detection.
mode          Enter the port mode
monitor       Configures an interface as span-destination
port-security Port security related command
trunk         Configure trunking parameters on an interface
vlan          Set VLAN translation mapping

(config-if)# switchport port-security ?
aging         Port-security aging commands
mac-address   MAC address
maximum Max   secure addresses
violation     Security violation mode