When I do 'show interface vlan19" (example) it shows no L3 counters.
This obviously worked on our 6500's but not on the Nexus. How do I enable it?
I don't want to use Netflow, we pull the traffic stats with SNMP.
"Show vlan counters" only shows L2 counters so not really useful.
Chassis : N9K-C93180YC-FX
BIOS: version 05.40
NXOS: version 9.3(4)
Example SVI:
Vlan19 is up, line protocol is up, autostate enabled
Hardware is EtherSVI, address is 003a.9c6b.b927
Description: network-hardware
Internet Address is X.X.X.X/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA
Last clearing of "show interface" counters never
L3 in Switched:
ucast: 0 pkts, 0 bytes
L3 out Switched:
ucast: 0 pkts, 0 bytes