cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1153
Views
0
Helpful
7
Replies
Participant

Nexus F2e & M1 compatibility

I see that the F2e and M1 can coexist in the same VDC, which is a good step forward. But I also read that and L3 functions are proxied from the F2e if there is an M1 present in the VDC.

Does this mean that if there is an M1 in the same VDC, an F2e cannot actually perform routing? So no routing adjacencies on directly connected interfaces? Can the L3 proxy be disabled?

7 REPLIES 7
Hall of Fame Community Legend

Nexus F2e & M1 compatibility

Does this mean that if there is an M1 in the same VDC, an F2e cannot actually perform routing?

That's correct.  If an F2e and M1/M2 are in the same vDC and you are running routing, the M1/M2 will take over the routing and F2e will "downgrade" itself to do nothing but Layer 2 stuff. 

This bit of information can be found in the Release Notes.

Beginner

Nexus F2e & M1 compatibility

Hi Leo,

Does the F2e support all routing functionalities in F2e-only VDC? (And the same with F2?)

Hall of Fame Community Legend

Nexus F2e & M1 compatibility

Does the F2e support all routing functionalities in F2e-only VDC? (And the same with F2?)

Define "all routing functionalities".   If I remembered correctly if you want to do MPLS, M1/M2 are primed to do this. 

Highlighted
Beginner

Nexus F2e & M1 compatibility

For example is it possible to do OSPF, BGP with all protocol features on F2/F2e modules?

Beginner

Nexus F2e & M1 compatibility

I’ve hit an issue with an F2e/M1 VDC. I can’t create L3 routed interfaces or L3 port channels on the F2e line card ports.

Is this possible or is it a limitation when coexisting F2e/M1 line cards in the same VDC?

Running 6.2(2a), SUP2E

VDC XXXXXXX

limit-resource module-type m1 m1xl m2xl f2e

Hall of Fame Community Legend

Re: Nexus F2e & M1 compatibility

Gavin,

As far as I am aware, if there is an M1/M2 card in the same vDC, the F3 card is suppose to DOWNGRADE from Layer 3 to a Layer 2. M1/M2 card will take over all Layer 3 functions.

Sent from Cisco Technical Support Nintendo App

Beginner

Re: Nexus F2e & M1 compatibility

Thanks, I understand that but should you loose the ability to create no switchport layer 3 interfaces? I'm guessing SVIs will be allowed and proxy the L3 requests to the m1 card. I cannot create a routed port(no switchport) or a layer 3 port channel using an F2e port.

Sent from Cisco Technical Support iPhone App

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards